ACE4710 single arm configuration

[usman]

I would like to know whether we can configure ACE4710 in single arm mode. By single arm deployment I mean servers  and users are on the same ip network.

Regards

[Eric Rose]

Yes that is a possible and is also a common configuration.I would recommend source nat as part of your configuration. So the return traffic from the servers will go back to the ACE before going to the clients.

[usman]

Thanks for your reply, could you please provide some links to the docs which can help me out.

[Eric Rose]

Here is a link to the dynamic NAT/PAT

http://www.cisco.com/en/US/docs/app_ntwk_services/data_center_app_services/ace_appliances/vA3_1_0/configuration/security/guide/nat.html#wp1002097

Quick Config for PAT

http://www.cisco.com/en/US/docs/app_ntwk_services/data_center_app_services/ace_appliances/vA3_1_0/configuration/security/guide/nat.html#wp1009112

Here is a link to the configuration Guide.

http://www.cisco.com/en/US/products/ps7027/products_installation_and_configuration_guides_list.html