Is it possible to influence on a delay between ACE sending FIN for tcp probe and expecting FIN-ACK from real server (default 1 second). Customer don't want to use RST Sometimes happens that server is not responding in time.
probe icmp ICMP ICMP probe - there are no problems!
passdetect interval 15
passdetect count 4
probe tcp T-CTS1 TCP probe - FIN problems from time to time!
passdetect interval 60
passdetect count 5
From capture file it is seen that ACE4710 sends RST after 1 second after tcp session established. This is probably server problem (customer has already opened a case) but it might be a solution with ace to extend this delay. From your description you have 10 second delay. It should have something with probe value set?
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...