Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Activate circuit/interface on 11050

Is there a command to activate VLAN1? When I do "show circuit all" under circuit status it says "downipEnabled". How do I change down to active? The CSS is connected to 5509. I tried admin shutdown commands. The port on 5509 and e1 on CSS are 100-full duplex.

1 REPLY
Cisco Employee

Re: Activate circuit/interface on 11050

do a 'sho phy'

check that you have at least 1 interface up and that this interface is

under vlan 1.

Gilles.

122
Views
0
Helpful
1
Replies