When i configure VS with ANM the ACE gets crashed/reboot automatically. And also i see the ANM geting timedout after 10 minutes and the message i get is 'failed to deploy". Can someone assist me on this.
You cannot modify a virtual context with the CLI Sync Status Import Failed. You must synchronize the context before you can make changes to it. You can view CLI Sync Status and synchronize contexts from the Virtual Contexts table (Config > Devices > ACE).
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...