Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Best way to take server out of queue (when it hosts 100's of sites)

Does anyone have a good way to suspend a single physical server if it hosts 100's of services? (Without manually going into each service and suspending it and then re-activating it)? Say you have 10 physical servers that all host the same content. The content could be 500 www and 500 ssl services in the CSS. There is 100 content rules where each VIP and port # correlates to the 10 corresponding load balanced servers that are hosting the content. Now say you need to pull 5 servers out for maintenance. This would take an eternity to manually go suspend each service. ANY IDEAS???

Thanks.

jd

1 REPLY

Re: Best way to take server out of queue (when it hosts 100's of

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

164
Views
0
Helpful
1
Replies
CreatePlease login to create content