Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BOX-BOX redundancy using Ge port

Hi,

I have two CSS 11501 one in each location (distance around 7 km) I want to configure Box-box redundancy between these two CSS15001, I used the Ge port e9 to connect them using SM fiber directly between these two switches. The link is not comming up. Need help and suggestion to over come this.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: BOX-BOX redundancy using Ge port

Hi,

the SFP GBICs should probably be at least a 1000Base-LH (1310nm) witch shold cover approx 10Km on single mode fiber.

Hope this helps.

Fulvio

2 REPLIES
New Member

Re: BOX-BOX redundancy using Ge port

Hi,

the SFP GBICs should probably be at least a 1000Base-LH (1310nm) witch shold cover approx 10Km on single mode fiber.

Hope this helps.

Fulvio

New Member

Re: BOX-BOX redundancy using Ge port

Hi,

Thanks for the reply, I checked it is fibre issue, which I have sorted out.

188
Views
0
Helpful
2
Replies