Browsing a virtual server from a member real server.
I am new to configuring a Local Director 430 but after setting up a basic configuration such as
Bind 10.1.1.1:80 10.1.1.2:80
Bind 10.1.1.1:80 10.1.1.3:80
The LD 430 seems to be working correctly when accessing the virtual server remotely. However if logged into one of the Real servers that is bound to the virtual, web pages will not display when trying to access the virtual server. Is this normal operation for the LD 430.
Re: Browsing a virtual server from a member real server.
Yes, this is normal behavior. Since the LD is L2 device, it cannot redirect same incoming and outgoing traffic on the same interface. For load balancing to occur (accessing the vip), the request must go across the LDIR. Meaning packet comes into the vip on e0 from the router, load balanced, and out on e1 to the servers.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...