Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Can I put two Content Network Modules in a Single 6500

We will be replacing our fault-tolerant CSS11506  with WS-X066-SLB-S-K9 modules.  Can I put two of them in a single 6513 and configure them for failover?  Or is there a limit to one module per chassis?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Can I put two Content Network Modules in a Single 6500

Hi Tim,

You can put both CSM-S in the same chassis if you want, and operate them as a FT pair.  Actually, you can put up to four of them in a single chassis.

Regards,

Sean

1 REPLY
Silver

Re: Can I put two Content Network Modules in a Single 6500

Hi Tim,

You can put both CSM-S in the same chassis if you want, and operate them as a FT pair.  Actually, you can put up to four of them in a single chassis.

Regards,

Sean

259
Views
0
Helpful
1
Replies
CreatePlease to create content