05-10-2007 09:09 PM
Could anyone advice me - can I use 1GE ethernet port on second SCM module in slot2?
# sh chassis
1 CSS5-SCM-2GE primary
2 CSS5-SCM-2GE backup
Any comments will be appreciated
Thanks in advance
Solved! Go to Solution.
05-14-2007 04:59 PM
Hi,
Unfortunately, the secondary SCM on a CSS11506 is backup and would not be online until the primary fails. This means that it cannot be used at all while the primary SCM is working properly. Check this link as reference:
http://www.cisco.com/univercd/cc/td/doc/product/webscale/css/11500fru/scm_2gen.pdf
I hope this helps. Thanks!
Regards,
Jose Quesada.
05-14-2007 04:59 PM
Hi,
Unfortunately, the secondary SCM on a CSS11506 is backup and would not be online until the primary fails. This means that it cannot be used at all while the primary SCM is working properly. Check this link as reference:
http://www.cisco.com/univercd/cc/td/doc/product/webscale/css/11500fru/scm_2gen.pdf
I hope this helps. Thanks!
Regards,
Jose Quesada.
05-14-2007 10:14 PM
Jose,
Great thanks for the reply. So, it also can not replace the SAM module to do similar work, right?
Please advice.
05-15-2007 06:58 AM
Hi,
You are right, the secondary SCM would not be used at all. So it cannot replace the SAM module.
I hope you find this information helpful. Thanks!
Regards,
Jose.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide