Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can you use WAEs for conns going over IPSEC?

Question: Can you place WAEs and optimize traffic and then place over IPSEC? Has anyone done this and have you experienced sufficient optimization? I'm picturing some in-line module WAEs between enddevices and IPSEC routers and wanted to know if I could expect typical optimization performance.

Thanks! Mike.

2 REPLIES
Cisco Employee

Re: Can you use WAEs for conns going over IPSEC?

Mike,

Are planning to deploying the WAE's in the traffic prior before/after IPSec encryption occurs? If so, you should be fine.

Zach

New Member

Re: Can you use WAEs for conns going over IPSEC?

Yes, it would be the non-IPSEC traffic. IPSEC would be on the inside of the WAE WAN interfaces. Thanks!

131
Views
5
Helpful
2
Replies