Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cannot PING!

Hello

I am using a CSS11503 and I am having a problem pinging a device on the same vlan as one of the interfaces on the content switch. Interface 3/3 is connected to port 1 on switch A and has an IP address of 10.40.29.64/28. The server has an address of 10.40.29.65/28 with its gateway set to 10.40.29.64. It is connected to port 2 on switch A. Port 1 and 2 reside on vlan 103 on the switch. The interfaces on the switch and CS are up, the circuit is also up on the CS. I cannot ping the gateway from the server. My config is as follows

dndcclbtest01# sh run

!Generated on 12/04/2007 23:22:31

!Active version: sg0730106

configure

!*************************** GLOBAL ***************************

date european-date

acl enable

flow tcp-reset-vip-unavailable

cdp run

ssl associate rsakey ugwebtstssl ugwebtst

ftp-record bof-ftp 10.146.13.150 anonymous des-password

ip route 0.0.0.0 0.0.0.0 10.40.21.250 1

!************************* INTERFACE *************************

interface 3/1

bridge vlan 102

description "dndcctbdmzsw1-vlan102-10.40.29.144/28-TESTBED"

interface 3/2

bridge vlan 5

description "dndccmlsa41"

interface 3/3

description "dndcctbdmzsw1-vlan102-10.40.29.160/28-TESTBED"

phy 100Mbits-FD

bridge vlan 103

interface 3/4

description "dndundrumswa43-fa0/23-vlan1-10.152.21.0"

!************************** CIRCUIT **************************

circuit VLAN1

ip address 10.152.21.6 255.255.255.0

circuit VLAN102

ip address 10.40.29.149 255.255.255.240

circuit VLAN5

ip address 10.40.21.25 255.255.255.0

circuit VLAN103

ip address 10.40.29.164 255.255.255.240

!************************** SERVICE **************************

I must be missing something. Any ideas of what I could be doing wrong?

Thank You

Regards

Donagh

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: cannot PING!

Hi Donagh,

Could you attach the configuration part of the CSS related to the ACLs? Also, can you get this output: sh ip route'. Thanks!

Regards,

Jose Quesada.

2 REPLIES
Bronze

Re: cannot PING!

Hi Donagh,

Could you attach the configuration part of the CSS related to the ACLs? Also, can you get this output: sh ip route'. Thanks!

Regards,

Jose Quesada.

New Member

Re: cannot PING!

Hi Jose

When I saw the word ACL I knew immediately that I had overlooked this. I added an ACL to circuit 103 permitting everything and it is working fine. Thanks!

Regards

Donagh

102
Views
0
Helpful
2
Replies