cant add an ASA firewall on the Cisco Network Assistant community
I've tried to add my ASA firewall on the modify button of my current community and after i entered the ip of the ASA it prompted me to accept the certificate and enter my credentials but after all that it returned an error "unsupported device type: Unknown cannot add device 192.168.x.x to community"
how do i add my ASA firewall so that i could see it in my topology view?
Re: cant add an ASA firewall on the Cisco Network Assistant comm
Cisco PIX 515E Firewalls. PIX Firewalls do not support the Cisco Discovery Protocol, so they are not automatically shown as neighbors in the Topology view. They are shown only after you add them to a community by using a Create Community or Modify Community window. To see a PIX Firewall link to another community member, you must add the link manually by selecting Add Link in a Topology popup menu
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...