Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

CE550 and two backbone

Hi,

we are using CE550 and 7200VXR , we have two range ip and two backbone

how can using these two backbone by one CE550 ?

it seems CE550 can have one ip address and using that .... i don't know how to setup it for two ip addresses (tcp outgoing) for using two backbone.

i would be appreciate if you advice me.

Regards,

M.Arshad Rad

1 REPLY
Cisco Employee

Re: CE550 and two backbone

if you have 1 router and 2 backbone, it means the router is attached to both.

Therefore, I would suggest to simply put the CE in one of the backbone and use wccp to transparently redirect traffic from both backbone to the CE.

For example, assume your 2 backbone are respectively on interface fast 0/0 and fast 0/1.

You will put the CE on interface fast 0/0.

On the router you will configure

ip wccp version 2

ip wccp webcache

interface fast 0/0

ip route-cache same-interface

! important because this is where the cache is located

ip wccp webcache redirect in

!

interface fast 0/1

ip wccp webcache redirect in

!

On the cache, use just 1 interface with 1 ip address from the backbone 1 range. Then configure

wccp router-list 1

wccp version 2

wccp webcache router-list 1

Hope this help.

Gilles.

236
Views
0
Helpful
1
Replies
CreatePlease to create content