Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Change of ACE peer hostname

I found the following entry in ACE administration guide but it doesn't work

peer hostname xxxxx

This is to set the secondary units' hostname.

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Change of ACE peer hostname

The code you are running A1(6.3a) doesnt support this command.

Syed Iftekhar Ahmed

Re: Change of ACE peer hostname

Yes with "no peer hostname" command support on code 1.63 you need to put the hostname on standby before FT configuration.

Syed

5 REPLIES

Re: Change of ACE peer hostname

This command is in newer codes (2.x) only.

What code are you running?

Are you not seeing this command at all or its there but is not working for you?

Syed Iftekhar Ahmed

New Member

Re: Change of ACE peer hostname

I don't see the command at all. Is this command applicable to global config mode.

The 'show version' output is

Cisco Application Control Software (ACSW)

TAC support: http://www.cisco.com/tac

Copyright (c) 2002-2006, Cisco Systems, Inc. All rights reserved.

The copyrights to certain works contained herein are owned by

other third parties and are used and distributed under license.

Some parts of this software are covered under the GNU Public

License. A copy of the license is available at

http://www.gnu.org/licenses/gpl.html.

Software

loader: Version 12.2[121]

system: Version 3.0(0)A1(6.3a) [build 3.0(0)A1(6.3a) adbuild_02:16:25-2008/

02/02_/auto/adbu-rel3/ws/rel_3_0_0_a1_6.3-throttle/REL_3_0_0_A]

system image file: [LCP] disk0:c6ace-t1k9-mz.3.0.0_A1_6_3a.bin

installed license: no feature license is installed

Re: Change of ACE peer hostname

The code you are running A1(6.3a) doesnt support this command.

Syed Iftekhar Ahmed

New Member

Re: Change of ACE peer hostname

So, does it mean the only way to change hostname is after removing the FT group and before reinstating it on the standby module.

Re: Change of ACE peer hostname

Yes with "no peer hostname" command support on code 1.63 you need to put the hostname on standby before FT configuration.

Syed

266
Views
0
Helpful
5
Replies
CreatePlease login to create content