Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

changing ports

I am running out of IP's in a DMZ I have... I have a CSS in there.... Can I run a webserver on a different port of one of my servers.... and use the css to translate inbound port 80 and/or 443 traffic to the correct port based on URL?

What would that be called I've been looking at things on port mapping and redirection but haven't found a thing yet...

Thanks...

1 REPLY

Re: changing ports

You sure can..

You just need to define a different port number in service configuration

In the following example CSS is expecting the client traffic on Virtual ip y.y.y.y and on port 80. Content rule web_servers will loadbalance the connection between server1 (x.x.x.1) & Server2 (x.x.x.2) and "port 8080" under service config will translate the destination port to port 8080.

content Web_Servers

add service server1

add service server2

vip address y.y.y.y

vip-ping-response local-remote

protocol tcp

port 80

active

service server1

ip address x.x.x.1

port 8080

protocol tcp

active

service server2

ip address x.x.x.2

port 8080

protocol 8080

active

Thanks

Syed

239
Views
0
Helpful
1
Replies