08-06-2014 06:49 AM
I have a Cisco ACE 4710. Does this device have the ability to do rate limiting/traffic shaping on a per-session basis? For example, if I'm load balancing 2 real servers, can I tell the ACE to limit each session to "XX" amount of bandwidth?
08-06-2014 07:19 AM
Hi,
Yes this is possible. Kindly have a look at the below link :
http://www.cisco.com/c/en/us/td/docs/interfaces_modules/services_modules/ace/vA5_1_0/configuration/slb/guide/slbgd/rsfarms.html#wp1012881
Please visit section: Configuring Real Server Rate Limiting
Regards,
Kanwal
Note: Please mark answers if they are helpful.
08-06-2014 09:12 AM
So, it allows you to limit the bandwidth to a real server...but what I was asking was if you could limit bandwidth by session. So create a policy that states that no session should exceed "x" bandwidth.
08-06-2014 10:04 AM
Hi,
Sorry that feature is there. With ACE EOL, i am not sure we will have such a feature.
Rate-limit at rserver and serverfarm as well as in pmap to apply it to a policy are the only options. But again they are not specific to IP or session.
Regards,
Kanwal
Note: Please mark answers if they are helpful
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: