Re: Cisco ANM 4.1 and ACE Module: url-summary hits??
The ANM is meant as a configuration/monitoring tool and tends to lean away from troubleshooting directly. The ouput of the command that you are looking at is useful for monitoring, but the root command "show service policy" is generally used for troubleshooting, thus, it is not included currently. If it is a critical feature that you need, you can contact your sales engineer and request an enhancement to the ANM 4.1 GUI to add it in.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...