Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco CSS11501 - Interface Configuration

Is it possible to configure the port speed and duplex on the ethernet interfaces? If so, how would I do it?

1 REPLY
New Member

Re: Cisco CSS11501 - Interface Configuration

In interface configuration mode, use the 'phy' setting.

CSS(config-if[ 2/2])# phy ?

100Mbits-FD 10/100 ports only. Set to 100 Mbits/s, Full-Duplex

100Mbits-HD 10/100 ports only. Set to 100 Mbits/s, Half-Duplex

10Mbits-FD 10/100 ports only. Set to 10 Mbits/s, Full-Duplex

10Mbits-HD 10/100 ports only. Set to 10 Mbits/s, Half-Duplex

1Gbits-FD-asym Gigabit ports only. Set to Full duplex with asymmetric

pause toward link partner

1Gbits-FD-no-pause Gigabit ports only. Set to Full duplex with no pause

1Gbits-FD-sym Gigabit ports only. Set to Full duplex with symmetric

pause

1Gbits-FD-sym-asym Gigabit ports only. Set to Full duplex with symmetric and

asymmetric pause toward local device

auto-negotiate Allow the interface to auto-negotiate speed and duplex

mode.

248
Views
0
Helpful
1
Replies
CreatePlease login to create content