Problem QPM does not support an imported device's Cisco IOS version. The device is assigned the status "Unsupported", and no mapped OS version is assigned to it. You cannot perform any tasks on a device that has been assigned this status.
Solution If the device model is supported by QPM but the Cisco IOS version is not, you can upgrade the device to a supported Cisco IOS version, and then rediscover the device to make it available in QPM. Click Rediscover in the Device Table to have QPM query the device for the correct information.
Alternatively, if the Cisco IOS version is not supported, but you know that the IOS version's QoS features are the same as in a supported version, you can use the following workaround:
1. After you have added the device, in the Device Properties page, change the Mapped OS version to the supported OS version, and save the change.
2. Rediscover the device. The device status changes to OK.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...