Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Citrix CAG and CSS

I have a problem with Citrix dropping connections when going through the CSS.

I am just doing a L3 content and the CAG is handling all the SSL.

I have set the flow-timeouts and verified that flows are NOT timing out with a show flows.

I have enabled tcp fragments. Otherwise the config is very simple. Just two CAGs with a VIP to load balance.

When I go through the CSS, the connections are dropped after about 1 1/2 hours. The client side appears to issue a "FIN" Packet to close out the connection.

However, when we bypass the CSS, we DO NOT get this behavior.

Has anyone seen this or have any suggestions?

439
Views
0
Helpful
0
Replies