I can't figure out why this isn't working...it is basic config, and I am eventually trying to to back-end SSL termination. Need basic connectivity first though. If anyone can assist that would be great.
thanks in advance!
CSS11501# term len 0
CSS11501# sh run
!Generated on 01/15/2007 20:38:54
!Active version: sg0810106
configure
!*************************** GLOBAL ***************************
!************************* INTERFACE *************************
interface e1
phy 100Mbits-FD
description "SCTREC02"
bridge vlan 55
interface e2
phy 100Mbits-FD
description "SCTREC02-9/11"
bridge vlan 255
!************************** CIRCUIT **************************
circuit VLAN55
ip address 161.19.55.5 255.255.255.192
ip virtual-router 55
ip virtual-router 150 priority 105 preempt
ip redundant-interface 55 161.19.55.4
ip redundant-vip 150 161.19.55.8
circuit VLAN255
ip address 161.19.55.66 255.255.255.192
ip virtual-router 255
ip redundant-interface 255 161.19.55.65
!*********************** SSL PROXY LIST ***********************
ssl-proxy-list SSL-PROXY
ssl-server 1
ssl-server 1 vip address 161.19.55.8
ssl-server 1 cipher rsa-with-rc4-128-md5 161.19.55.8 443
ssl-server 1 unclean-shutdown
ssl-server 1 ssl-queue-delay 0
backend-server 20
backend-server 20 ip address 161.19.55.75
backend-server 20 port 443
backend-server 20 cipher rsa-with-rc4-128-md5
backend-server 10
backend-server 10 ip address 161.19.55.74
backend-server 10 port 443
backend-server 10 cipher rsa-with-rc4-128-md5
!************************** SERVICE **************************
service sctam103:1-1
ip address 161.19.55.74
protocol tcp
port 443
keepalive type tcp
keepalive tcp-close fin
keepalive port 443
active
service sctam104:1-1
ip address 161.19.55.75
protocol tcp
port 443
keepalive type tcp
keepalive tcp-close fin
keepalive port 443
active
!*************************** OWNER ***************************
owner AMLDAP
content services-sys:ssl
vip address 161.19.55.8
protocol tcp
port 443
add service sctam103:1-1
add service sctam104:1-1
active
CSS11501#
