Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Config Questions, New to CSS

Hello,

I am attempting the following.

1. Configure the CSS to load balance our web application between two geographic locations. MD and NJ.

2. Should one CSS fail the remaining device should pickup all DNS functions and route\direct users to the available web servers.

At this time. I can resolve the query to the CSS. I see the hits on the services iterate in a round robin fashion, but I get no web content on the requesting browser. I have simplified the config to not use SSL, but still getting the same result. If someone could point out the problem for me I would greatly appreciate it.

Current Configuration

We are using a CSS 11503.

A client DNS request for Foo.somebank.com resolves to one of our public IP addresses. Its then natted to one of our CSS devices for DNS resolution. The CSS should make an intelligent decision on content location at this point.

Internally, all systems are on private IP addressing.

|FWMD|-------|CSSMD|----|PCbanking0|

| | |PCbanking1|

| |

|FWNJ|---------|CSSNJ|------|PCbanking0|

|PCbanking1|

The config is below.

!Active version: sg0810106

configure

!*************************** GLOBAL ***************************

no restrict web-mgmt

dns-server zone 0 tier1 "pcbanking-MD" weightedrr 5

dns-record a test.pcbank.bank.local 172.16.31.9

dns-record a http://www.pcbank.bank.local 10.2.1.251

dns-server

app session 10.2.1.254

app

dns primary 10.2.16.21

dns secondary 10.2.16.22

dns suffix afcu.local

ip route 0.0.0.0 0.0.0.0 10.2.10.176 1

!************************** CIRCUIT **************************

circuit VLAN1

ip address 10.2.1.253 255.255.240.0

!************************** SERVICE **************************

service pcb1

ip address 10.2.16.200

active

service pcb2

ip address 10.2.16.201

active

!*************************** OWNER ***************************

owner BANK

dns both

content bankonline

protocol tcp

port 80

add service pcb1

add service pcb2

vip address 10.2.1.251

active

1 REPLY
New Member

Re: Config Questions, New to CSS

I figured it out.

Thanks for the help...

112
Views
0
Helpful
1
Replies
CreatePlease to create content