I have an application which makes an IP Socket connection between Point A and Point B. What I want to do is put the 11500 between these two points and configure it as follows: If the port is available, route using a persistent connection to Point B. However, if the persistent connection fails, try to reestablish it otherwise move the connection to Point C. I have 800 of these connections which I want to implement.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...