Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Content Engine: default password problem.

Hi there;

I'm working with a new, box fresh 2611XM, with the NM-CE-BP-40G-K9 Content Engine slotted in.

I've configured basic routing on the 2611, and have started a session on the CE using the "service-module content-engine1/0 session" command.

It's looking for a username/password combination.

I've tried the defaults that I know of, and were suggested by the supplier, namely:

admin/blank

admin/password

cisco/blank

cisco/password

in both upper and lower case, plus sundry other guesses- to no avail.

My supplier has suggested recovering the password using the technique of resetting the bootflags; however, at no point during the startup process am I presented with an option to change the bootflags.

So: am I doing something wrong?

And how do I know if it has the ACNS system installed; it makes no reference to it during boot-time.

cheers-

0r8it

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Content Engine: default password problem.

try admin/default

Regards

Pete Knoops

Cisco TAC

2 REPLIES
Bronze

Re: Content Engine: default password problem.

try admin/default

Regards

Pete Knoops

Cisco TAC

New Member

Re: Content Engine: default password problem.

Pete, that was awful fast work!

And the right answer: sensational!

Lovely- thanks again.

0r8it

242
Views
5
Helpful
2
Replies