08-25-2003 04:49 AM
Hi there;
I'm working with a new, box fresh 2611XM, with the NM-CE-BP-40G-K9 Content Engine slotted in.
I've configured basic routing on the 2611, and have started a session on the CE using the "service-module content-engine1/0 session" command.
It's looking for a username/password combination.
I've tried the defaults that I know of, and were suggested by the supplier, namely:
admin/blank
admin/password
cisco/blank
cisco/password
in both upper and lower case, plus sundry other guesses- to no avail.
My supplier has suggested recovering the password using the technique of resetting the bootflags; however, at no point during the startup process am I presented with an option to change the bootflags.
So: am I doing something wrong?
And how do I know if it has the ACNS system installed; it makes no reference to it during boot-time.
cheers-
0r8it
Solved! Go to Solution.
08-25-2003 04:58 AM
08-25-2003 04:58 AM
try admin/default
Regards
Pete Knoops
Cisco TAC
08-25-2003 05:16 AM
Pete, that was awful fast work!
And the right answer: sensational!
Lovely- thanks again.
0r8it
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: