Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

creating a rserver on the ACE module using ANM 2.1.1

Hello,

I tried to create a rserver on the standby VC on the ACE module using ANM. This rserver is displayed in the ANM (the transfering is done without any error message), but this rserver is not created on the standby VC. It is OK, but why the ANM displayed this new rserver in the rserver window and no error message was displayed about creating rserver on the standby VC. Is it bug or the normal behaviour of the ANM? Thanks. Roman

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: creating a rserver on the ACE module using ANM 2.1.1

Roman,

There were drastic improvements in later versions of ANM.  This specific bug is CSCtd28388.  There is HA logic that was being fixed in ANM software.  ACE will not allow certain changes to be configured depending on the HA state.  This logic will be fixed in an upcoming v4 release of ANM to give the user feedback from the ANM server if changes were or were not applied and why.

Kris

2 REPLIES
Cisco Employee

Re: creating a rserver on the ACE module using ANM 2.1.1

Roman,

There were drastic improvements in later versions of ANM.  This specific bug is CSCtd28388.  There is HA logic that was being fixed in ANM software.  ACE will not allow certain changes to be configured depending on the HA state.  This logic will be fixed in an upcoming v4 release of ANM to give the user feedback from the ANM server if changes were or were not applied and why.

Kris

New Member

Re: creating a rserver on the ACE module using ANM 2.1.1

Thank you. Roman

395
Views
0
Helpful
2
Replies
CreatePlease login to create content