I use a one arm solution ( Trunk interface) in active/standby environment made by 2 CSS 11501, working in router mode. They, each, connect to a separte swicth through the trunk interface. In such configuation, I ask,if configuring critical physical interface is suficient? the switchs are connect through a trunk interface also, and the server and client side are distributed among them in their respectives VLANS.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...