Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

CSM 3.2 & SUP720 compatibility

Are there any compatibility issues with ver 3.2 CSM code with the SUP720? My two CSM's in different chassis were working and after upgrading from SUP2's to SUP720's I cannot get FT to work. Both CSM's come up as active active and I have to shut one down to get server connectivity.

I want to verify before I upgrade CSM's to 4.2.

Thanks,

D.J.

1 REPLY

Re: CSM 3.2 & SUP720 compatibility

you can run CSM 3.2 code with 720.(

IOS 12.2(14)SX1 or CatOS 8.2.1 and greater needed)

Could you please check that CSM FT vlans are configured on both switches.(If vlan X is FT vlan then make sure that "vlan X" command exists on both switches.)

Syed

144
Views
0
Helpful
1
Replies
CreatePlease to create content