In the CSM documentation, it is stated that once a script is loaded in the CSM, it cannot be removed. It can only be replaced with "no script file" - "script file" commands. However, I see that if I remove the script file command from the configuration, the script do not stay in the CSM during a module reset or reboot...Does this mean that each time the CSM reloads, a TFTP server of a flash card has to be available to load the script ? Is there a mean to make the script permanent in the CSM ?
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...