Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CSM FT setting

Hi,

I need to discovery  members of a FT group set in a CSM LB.

I am on the Swicth_1 that is the standby and now I want to figure out which switch  is the primary.

Is there any useful command?

Thanks.

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions

CSM FT setting

Hi,

Cat6k-2# show module csm 4 ft

FT group 2, vlan 30

 This box is active

 priority 10, heartbeat 1, failover 3, preemption is off

http://www.cisco.com/en/US/docs/interfaces_modules/services_modules/csm/3.2/command/reference/s.html#wpxref93908

Jorge

2 REPLIES
Cisco Employee

CSM FT setting

Hi,

Please use command:  show module contentSwitchingModule 4 ft detail

The modules in FT will have same FT GROUP ID and usually it is recommended to have a different VLAN assigned for FT heartbeat exchange as well. So you can check manually on the basis of FT group ID which two modules are using it.

Another command which can be useful is: #show module contentSwitchingModule all ft

Regards,

Kanwal

CSM FT setting

Hi,

Cat6k-2# show module csm 4 ft

FT group 2, vlan 30

 This box is active

 priority 10, heartbeat 1, failover 3, preemption is off

http://www.cisco.com/en/US/docs/interfaces_modules/services_modules/csm/3.2/command/reference/s.html#wpxref93908

Jorge

338
Views
0
Helpful
2
Replies
CreatePlease login to create content