i want to change a probe for an active serverfarm. But after deleting the old probe and inserting the new one, all probe entries are cleared. What is the right handling to change a probe for an active serverfarm?
after configuring the new probe in serverfarm configuration mode i control the entry in the running config. But the line where the probe should appear in the particular serverfarm section is missing, there is no probe entry. If i reconfigure the probe i've used before, the old entry is visible again.
if i do the steps as per dsecription, the serverfarm has no probe entry anymore. Meanwhile i've solved the problem by setting the real servers in serverfarm submode in "no inservice". After that it is possible to delete the old probe and configure a new one in that mode.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...