I have a customer with a one arm setup. However they have no server vlan, only a client vlan. They are using source nat and it is working, however I am unsure how to setup redundancy as the alias command seems to be generally used on the server vlan.
i am running hsrp and a ft vlan accross the csm's
Does anyone have any experience of this type of setup, do i need to add any additional config for fault tolerence??
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...