I need the CSM to load share based on source TCP ports coming from a single "client" address while still using sticky?
The issue is that we are getting uneven load sharing on the web servers as we may see 100s of connections coming in hidden behind a single NAT (PAT) and staying on one server kicking up the connections. In many cases we cannot create NAT pools as we do not control the devices where the PAT originates.
When load balancing traffic runs through the CSM system, the Internet Exchange Point (IXP) engine statistics are of interest, because they depict the utilization of the CPUs involved in the switching or forwarding function.
In some scenarios, a high CPU load on the CSM blade can be seen in the Server Load Balancing (SLB) SendDraco thread of about 49 or 37 percent.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...