We have 6509 switch with FWSM (Bridged) and CSM in two different buildings, say site-A is Primary and site-B is DR. These two 6500 switch are configured with HSRP to decide primary. I can reach DR switch, FWSM and CSM but unable to reach the SSL module on DR side. Don't understand why. When I do ping, I get 1 successful reply after 10 - 15 failure ping request. I suspect it could be because of the bridged mode but not sure. Also I am doubt that is it possible to have CSM actvie / standby like this.
Would be grateful if could help me to understand on this.
The SSL module management IP is reachable intermittently. It respond 3 ping requests out of 10. So don't know what is happening with SSL module. When I do config sync from Primary switch CSM configs are get replicated successfully so it means intercommunication between Primay and Standby CSM is fine. Only problem to reach the SSL module in standby.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...