We have 2 Catalyst 6500s with CSM-S cards installed. The CSMs are in redundant configuration already. The SSL offloading is configured in bridged mode. CSM provides redundancy for the client VLAN. How do we provide redundancy for the SSL cards? Do we use HSRP for the bridged VLAN that exists in the SSL? Do we use HSRP for the SSL admin VLAN? Is there a document the references redundancy configuration specifiacally for the CSM-S (SSL daughter cards)? Thanks.
Guess, this link does not help much for the SSL redundancy.. Does anyone have some working configs..?
George, Did you get this working... If so, would you mind sharing your configs.. I have a similar requirement, but i have my SSL offloading in routed mode, whereas the Web Client/Server Vlans are in bridged mode.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...