05-23-2006 10:45 AM
I have configured the
CSM with sticky on all vservers. The one problem I am having is the programmers that need to get directly to the server cannot, they are stuck on the server they inially attached to, they cannot even connect using telnet or http. What am I missing or what do I need to add to allow them to access servers, bypassing the sticky???
05-23-2006 10:48 PM
Hi Thornick,
If you say that they are always stuck to the same server,
then they go to the server via the virtual ip address and NOT directly.
I assume that de servers are directly attached behind the CSM blade.
One possible solution could be to use a policy serverfarm (in your VSERVERs)
which is not sticky and also use the client group option within this policy serverfarm.
This client group refers to an access-list containing all ip addresses of
your programmers PC's.
Greetings, Wim
05-24-2006 05:52 AM
create a vserver for the server vlan ie: 10.10.10.0/24 and use a serverfarm as below
serverfarm route
no nat server
no nat client
predictor forward
!
Do not configure stickyness on this vserver.
Your programmers should have direct access to the real servers now.
Gilles.
05-26-2006 06:34 AM
Thank you! Problem solved
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: