There are two separate Cat6513 chassis each contain a CSM.We configured as active/standby mode. In future, we will upgrade image of CSM from 4.2(3) to 4.2 (11). After I finish upgrade image and reboot the standby one,
My question is if the A/S mode could be generated because of different image at that time?
Through the CSM configurationguide 4.2 from Cisco website, I found the topic "Configuring a Hitless Upgrade". Another question is when we will reboot the active CSM. Until old standby one is online?
It supports synchronizing the configuration between the active and the standby CSM over the fault-tolerant VLAN. While the active CSM is rebooting the standby CSM will take over and become active. If you've configured the active CSM with a higher priority and preempt that it would become active after reboot otherwise the standby will stay active.
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...