09-04-2003 09:15 AM
We bought 2 css switches so we can do redundancy but when I boot up the other switch it goes directly to OFFDm. The other one boots up fine to the Cli prompt. I am new to this appliance. Am I missing some kind of config?
Thanks,
gilbert
Solved! Go to Solution.
09-04-2003 09:26 AM
Gilbert,
In the OffDM, check to make sure the boot setup is configured for D - disk and select the code. It may still be configured for N - network.
Also make sure there is atleast one flash card in the pcmcia slot. If so, you can also move the card to the other slot and boot.
Regards
Pete Knoops
Cisco TAC
09-04-2003 09:26 AM
Gilbert,
In the OffDM, check to make sure the boot setup is configured for D - disk and select the code. It may still be configured for N - network.
Also make sure there is atleast one flash card in the pcmcia slot. If so, you can also move the card to the other slot and boot.
Regards
Pete Knoops
Cisco TAC
09-04-2003 09:43 AM
Thanks Pete!
THe Card was not inserted properly and I had to point it to boot to Disk.
Thanks again
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: