Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Css 11500

We bought 2 css switches so we can do redundancy but when I boot up the other switch it goes directly to OFFDm. The other one boots up fine to the Cli prompt. I am new to this appliance. Am I missing some kind of config?

Thanks,

gilbert

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Css 11500

Gilbert,

In the OffDM, check to make sure the boot setup is configured for D - disk and select the code. It may still be configured for N - network.

Also make sure there is atleast one flash card in the pcmcia slot. If so, you can also move the card to the other slot and boot.

Regards

Pete Knoops

Cisco TAC

2 REPLIES
Bronze

Re: Css 11500

Gilbert,

In the OffDM, check to make sure the boot setup is configured for D - disk and select the code. It may still be configured for N - network.

Also make sure there is atleast one flash card in the pcmcia slot. If so, you can also move the card to the other slot and boot.

Regards

Pete Knoops

Cisco TAC

New Member

Re: Css 11500

Thanks Pete!

THe Card was not inserted properly and I had to point it to boot to Disk.

Thanks again

109
Views
0
Helpful
2
Replies
CreatePlease login to create content