I have a CSS 11501 connected to a 3750 with a crossover cable. I am seeing that almost every packet that travels to the 3750 is being considered a runt. Any ideas?
3750 Interface
interface GigabitEthernet1/0/21
description Connection to CSS
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,28
switchport mode trunk
duplex full
speed 100
SWT03SRV#sh int g 1/0/21
GigabitEthernet1/0/21 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 000f.2325.4695 (bia 000f.2325.4695)
Description: Connection to CSS
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 234/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 2000 bits/sec, 2 packets/sec
5 minute output rate 14000 bits/sec, 16 packets/sec
3780034 packets input, 513917174 bytes, 0 no buffer
Received 49995 broadcasts (0 multicast)
626300 runts, 0 giants, 0 throttles
626300 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 17613 multicast, 0 pause input
0 input packets with dribble condition detected
49231007 packets output, 688541161 bytes, 0 underruns
0 output errors, 367 collisions, 1 interface resets
0 babbles, 78 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
CSS Interface
interface e1
description "Connection to 3750-SRV"
phy 100Mbits-FD
trunk
vlan 1
default-vlan
vlan 28