I just setup two CSS 11503 switches as Active/Passive fail over. The GE ports on the SCM are connecting directly between the two switches. You need to setup Adaptive Session Redundancy. So, in all your circuits, services, content rules add redundant indexes. In your SCM GE port add Inter-Switch communications. Last, you need to add critical-services to all your circuit VLANs. If you need more info e-mail me at email@example.com
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...