Css 11801 When suspending and activating a rule, other rules may lock up re
We have configured a set of rules under an owner. When we suspend any one rule, it causes a knock on effect resulting in one or two other rules ( under the same owner) to lock up. These then require suspending / activating afterwhich they work ok.
s/w is enhanced feature set ap0500033 ( 5.00 Build 33)
It is intermittent with regards to which particular rule will lockup. Can anyone please advise?
Re: Css 11801 When suspending and activating a rule, other rules
I am not aware of this behaviour. However, ensure that you have configured the owners and the rules according to the documentation available. And also use the suspend command to suspend a rule. The documentation is available here:
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...