Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CSS configuration examples for "portmap vip-address-range"

Does anyone have a clear example of a full configuration including the "portmap vip-address-range" Command?  I've done plenty of searches and the best I can come up with is a description along with the CLI command.  No where can I find a full configruation example of a CSS using the portmap.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: CSS configuration examples for "portmap vip-address-range"

Here is the information I have

Here is a configuration example of a Source Group with 3 VIP addresses:
(config)# group ftpgroup
(config-group[ftpgroup])# vip address 192.168.1.10
(config-group[ftpgroup])# portmap vip-address-range 3
(config-group[ftpgroup])# add destination service ftp-svc1
(config-group[ftpgroup])# add destination service ftp-svc2

(config-group[ftpgroup])# active

But, the whole concept of range on the CSS is not very helpful.

If you want to use a range, you need to apply the same range command to vip, group AND service.

Then, when a user comes to vip range X, we select service range X, and group range X....the same index in each.

Gilles.

2 REPLIES
Cisco Employee

Re: CSS configuration examples for "portmap vip-address-range"

Here is the information I have

Here is a configuration example of a Source Group with 3 VIP addresses:
(config)# group ftpgroup
(config-group[ftpgroup])# vip address 192.168.1.10
(config-group[ftpgroup])# portmap vip-address-range 3
(config-group[ftpgroup])# add destination service ftp-svc1
(config-group[ftpgroup])# add destination service ftp-svc2

(config-group[ftpgroup])# active

But, the whole concept of range on the CSS is not very helpful.

If you want to use a range, you need to apply the same range command to vip, group AND service.

Then, when a user comes to vip range X, we select service range X, and group range X....the same index in each.

Gilles.

New Member

Re: CSS configuration examples for "portmap vip-address-range"

Thanks for the comment.  Yes, I'll gladely say the documentation available for this command

is VERY lacking.  I did figure out what your saying on my own, but it took some time.

Thanks again.

514
Views
0
Helpful
2
Replies