I have 2 CSS 11150 , I want to configure for fault-tolerant (Active and Standby). If one is down, another will take over.But I dont know the way that I did it right or not. It is the first time i have worked with CSS. Any advice would much appreciate. Thanks
CSS1(Active)
Circuit VLAN1 (Connect to Server farm)
Ip address 192.168.4.253/24
Ip virtual-router 1 priority 110 preempt
Ip redundant-interface 1 192.168.2.4.252
Ip critical-service 1 Critical
Circuit VLAN2 (Public Network)
Ip address x.y.z.186 /24
Service Critical
Ip address 192.168.4.254 # Ip address of Css2
type redundancy-up
active
CSS2(Standby)
Circuit VLAN1 (Connect to Server farm)
Ip address 192.168.4.254/24
Ip virtual-router 1 priority 100 preempt
Ip redundant-interface 1 192.168.4.252
Ip critical-service 1 Critical
Circuit VLAN2 (Public Network)
Ip address x.y.z.187 /24
Service Critical
Ip address 192.168.4.253 # Ip address of Css1
type redundancy-up
active
Default Gateway of server farm points to 192.168.4.252. Vlan on each CSS is connected to L2 switch. I also have 2 3640 routers connected to same switch with CSS Vlan2 running HSRP.