Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

css redundancy

hi,

looking to have a failover solution for css. below is the version

Version: sg0750004 (07.50.0.04)

Flash (Locked): 07.10.1.02

Flash (Operational): 07.50.0.04

Type: PRIMARY

Licensed Cmd Set(s): Standard Feature Set

questions

do we need to upgrade the version

how does the redundacny works

all are servers are directly connected to a single css. when we connect the second css how can we connect these servers? we can team them but connecting directly to css can cause problem. ideally we want to connect them directly to the servers and thats how the original config is on the existing servers

1 REPLY
Bronze

Re: css redundancy

Ideally for redundancy you would need to connect the servers to an another switch and then the 2 redundant css boxes into the same switch.

The code you are running is old and you would want to run the latest 8.20 code on CCO.

http://www.cisco.com/kobayashi/sw-center/index.shtml

go to the section Application Networking Services for the CSS code (WebNS)

117
Views
0
Helpful
1
Replies