cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
382
Views
5
Helpful
3
Replies

CSS with one leg

keithredding
Level 1
Level 1

The CSS installation I've inherited is working fine load-balancing web content to the outside world.

It has one physical ethernet connection but NO interface definition statements and only 1 circuit defined - vlan 1 - with a single IP address.

I'd really like to know how this setup works, but can't find it explained in ANY of the manuals...

1 Accepted Solution

Accepted Solutions

Gilles Dufour
Cisco Employee
Cisco Employee

by default, all physical interfaces are in bridge vlan 1.

This is why it works.

If the circuit vlan was using a different vlan id than 1, you would have to configure a physical interface to be in this particular vlan.

Gilles.

View solution in original post

3 Replies 3

Gilles Dufour
Cisco Employee
Cisco Employee

by default, all physical interfaces are in bridge vlan 1.

This is why it works.

If the circuit vlan was using a different vlan id than 1, you would have to configure a physical interface to be in this particular vlan.

Gilles.

Thanks for that. Now I understand. How did you discover it - thought I'd looked everywhere.

I'm just a software engineer for the CSS and after 4 years working with this product, I learned a few tricks :-)

Gilles.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: