I have a CSS10500 switch and i would like to load balance the connections to a couple of hosts. My setup (roughly) is as follows
int e1-RTR1-------->int e2-Host1
int e5-RTR2------>int e6-Host1
How can i assing different interfaces to the two sets of hosts??? I want all ports (0-65535 and tcp/udp) to go to both sets. I made a circuit vlan 1 and assigned it an ip address but i cannot make a circuit vlan 2 and when i assign multiple addresses to vlan1 i cannot somehow assign interfaces to each ip.
Is there anything i can do??
Sorry for all the fuss i am new to the CSS concept.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...