I am setting up a new nameserver network site and have the following equipment:
- Cisco 2811
- Cicso CSS11501
- Cisco Catalyst 2960
This site will have 2 nameservers which I want to load-balance behind the CSS11501. The network will be setup like this:
Nameservers 1 & 2
The CSS11501 will be in routed mode and will have a publicly addressed VIP (eg, 203.x.x.x) for the DNS service and the name servers will be privately addressed (eg, 10.x.x.10 & 10.x.x.11). I'm hoping this will work fine and serve the requested IPv4 DNS requests.
I would like the nameservers to also operate on IPv6 and serve out IPv6 DNS requests but am not sure the CSS11501 can perform IPv6 service load-balancing.
My question is, does the CSS11501 support IPv6, load-balancing IPv6 service requests?
On another site I was looking at rolling out a Catalyst 6500 CSM module to do the exact same thing as the site I have the CSS11501's at, but it too does not support IPv6 from all I could find. Does the ACE provide all the functionality of the CSM plus IPv6?
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...