Can someone explain to me the way that 'add service' and 'add destination service' commands work when groups are configured. The config guide wasn't too clear on this point assuming a wider knowledge of this subject I think. We have 3 content rules configured and 6 services. No ACLs. 3 groups configured to handle NAT from the content rules to the services using the content rule VIP address as the address for the group. We are using 'add destination service' command to point at groups of back-end servers.
Any light shed on this subject would be most appreciated.
The add service command is used when you want to NAT the source ip when the servers initiate connection to the outside of CSS.
The add destination command is usually used in a one armed config ( For eg . When the CSS and the servers are hanging from the same CAT switch). It NATS the source ip of the client and makes sure that the servers reply back to the CSS.
Introduction This article will help you understand the steps on how to
download the UCS licenses from the Cisco Systems website and then
installing it on the UCS. The redacted (blue lines) just covers up
certain numbers for privacy please do not take them...
Introduction This article will help you understand and educate the
customer on how to clear their "expired licenses"
(license-graceperiod-expired) from their UCS-M. If a customer just
purchased a license and needs a step by step guide on how to download
With Vignesh R. P.Welcome to the Cisco Support Community Ask the Expert
conversation.This is an opportunity to learn and ask questions of Cisco
expert Vignesh R. P. about the Cisco® Nexus 7000 Series Switches and
support for the Cisco NX-OS Software platf...