Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Debug show ACE 4710 load balancing

Hello,

I'm using an ACE 4710 to balance http connection toward 2x proxy cache (cache1 & cache2). I would like to debug to which of the cache is redirected the request. Does someone have a debug command or a show command that permit to do it ?

Pratically I'd like to have the possibility to see where the packet was directed to (next hop) based on the L7 loadbalance policy.

1 REPLY
Cisco Employee

Re: Debug show ACE 4710 load balancing

if you do a 'show conn' you should see the connection id.

Then do a 'show np 1 me-stat "-c "'

There you should get a line with :

EncapsID:ver : 19:0

Then do a 'show arp' and check the entry whose encap column matches the encapid found previously.

You could also do a 'show serverfarm' and see which rserver has the current counter at 1 if you are working with 1 connection at a time.

Gilles.

736
Views
0
Helpful
1
Replies